United Static Control Products, Inc

Application: Best results are obtained when ElectraSeal is applied to cured concrete surfaces which are 60 Deg F. or warmer and in relative humidity conditions of < 50%. Thoroughly vacuum slab to remove any loose dirt or dust.  If contaminants such as oil and grease have soaked into the slab wash with ElectraClean rinse slab and allow to dry completely prior to application of ElectraSeal. Three coats will provide the optimum gloss and durability. Apply thin even coats using new loop end rayon or other non linting finish mops, allowing ElectraSeal to dry, (depending on humidity and temperature) for approximately 60 minutes between coats. Typical life span of product is at least 3 years. ElectraSeal may be effectively recoated without removal. For best results do not burnish.  If a higher luster is required top coat this material with one thin coat of ElectraGlaze floor finish prior to high speed polishing.

Maintenance: ElectraSeal is an extremely durable Anti Static concrete sealer. After application and curing of ElectraSeal routine maintenance (to be expected with any floor) is all that is required to maintain the luster and conductivity of the finish.  It's important to remove abrasives that can scratch and degrade the conductivity by dry mopping (usually on a daily basis).  On an occasional basis (most of our clients prefer to do this once every week or two) damp mop the floor with a diluted mixture of ElectraClean and water and allow to dry. Note: Use only ElectraClean to damp mop your ElectraSeal floor,NEVER wash any esd floor with plain water. ElectraSeal does not readily lend itself to high speed polishing or burnishing.  If a high speed polishing (produces ultimate shine) is desirable top coat the ElectraSeal with a single coat of ElectraGlaze prior to polishing.