United Static Control Products, Inc

This quart sample of ElectraThane is used to seal ElectraGuard epoxy. ElectraThane is tougher than ElectraGlaze but is not designed to be high speed polished. This can be top coated with ElectraGlaze for a higher shine and high speed polishing. for more information on ElectraThane click here!

• MSDS SHEET

• APPLICATION: ElectraThane is recommended for applications on Stone Hard and Garland standard Epoxy and fully cured ElectraGuard ESD Epoxy (minimum curing time of ElectraGuard is 3 days at > 60 Deg F with adequate air movement) and in relative humidity conditions of < 50%. Thoroughly remove loose dirt and dust via sweeping (do not use sweeping compounds).  Remove imperfections if any (such as bubbles and splatters) from ElectraGuard via light scraping followed by vacuuming . Agitate ElectraThane sealant in container prior to use, pour into clean contaminant free bucket and mop on one thin even coat using non linting synthetic finish mops.  Allow coat to dry (depending on humidity and temperature) for 60 to 90 minutes before re-application of second coat. Two coats are recommended, three coats are optimal. Effective recoating may be achieved in the following manner: Vacuum the floor to remove any loose dirt or dust. Wash the floor with ElectraClean to remove dirt and soil, allow to dry thoroughly. Apply thin even coats using a lint free finish mop.  Allow ElectraThane to dry for approximately 90 minutes between coats and before resumption of foot traffic. Allow to dry 24 hours prior to resumption of heavy rolling loads.
• ROUTINE MAINTENANCE:ElectraThane sealer is an extremely durable sealer. After application and curing of ElectraThane routine maintenance (to be expected with any floor) is all that is required to maintain the luster and conductivity of the finish.  It's important to remove abrasives that can scratch and degrade the conductivity by dust mopping (usually on a daily basis).  On an occasional basis (most of our clients prefer to do this once a week) wet mop the floor with a diluted mixture of ElectraClean and water and allow to dry. ElectraClean works great with power scrubbing equipment OR in hand mop applications.  ElectraClean removes dirt and abrasives that dry mopping leaves behind and smells great too.  Note: Do not wash your ElectraThane ESD Floor sealer for at least 48 hours after application and NEVER wash ElectraThane with plain water (always use ElectraClean diluted with water) for damp moping.