ESD Clear Coat for VCT and Hard Surface Flooring

Static Control Equipment

ESD Flooring & Floor Care

Static Control for Offices

Sample Request

All Samples

Home > ElectraGuard Static Control Floor Paint > ElectraGuard Sealers and Top Coats >

ElectraThane Specialty Sealer - 5 Gallon Pail

AntiStatic Clear Coat for Standard and Conductive Epoxy Flooring

ElectraThane Sealer / Finish. ONLY from United SCP!

Outstanding static dissipative properties reduces nuisance static on standard VCT, sheet vinyl and thick set epoxy. Used to tailor the Electrical Conductivity of ElectraGuard and provide shine, gloss and added durability.

Our Price: $370.87

Sale Price: $318.95

You save $51.92!

Product Code: ETHANE-5

Qty:

Description

Technical Specs and Downloads

Extended Information

ElectraThane anti-static clear coat is designed to reduce nuisance static on all types of hard surface flooring. It's much more robust than ANY esd floor finish. It's easier to apply, longer lasting and provides THE most reliable and electrically stable static dissipative properties of any clear coating on the market. When applied to ElectraGuard static conductive ESD Epoxy, ElectraThane will slightly raise the insulative properties while increasing shine and cleanability. This attribute is helpful when "adjusting" the electrical resistivity upwards for munitions flooring that must comply with DoD 4145.26-M (March 13,2008). ElectraThane may also be used for elimination of nuisance static generation encountered with Garland, Sika, Stonehard and any other thick set standard epoxy flooring. ElectraThane also features excellent recoatability and (in the case of aggressive contamination) may be removed (with effort) and re-applied. ElectraThane is designed for mop on applications (2 to 4 coats) depending on the substrate.

SDS SHEET

APPLICATION: ElectraThane is recommended for applications on all standard hard surface flooring and fully cured ElectraGuard ESD Epoxy (minimum curing time of ElectraGuard is 3 days at > 60 Deg F with adequate air movement). Thoroughly remove loose dirt and dust via sweeping (do not use sweeping compounds). Agitate ElectraThane ClearCoat in container prior to use, pour into clean contaminant free bucket and mop on one thin even coat using non linting synthetic finish mops. Allow coat to dry (depending on humidity and temperature) for 60 to 90 minutes before re-application of second coat. Three to Four coats are recommended for hard surface flooring. 2 coats maximum are recommended for ElectraGuard. Effective recoating may be achieved in the following manner: Vacuum the floor to remove any loose dirt or dust. Wash the floor with ElectraClean to remove dirt and soil, allow to dry thoroughly. Apply thin even coats using a lint free finish mop. Allow ElectraThane to dry for approximately 90 minutes between coats and before resumption of foot traffic. Allow to dry 24 hours prior to resumption of heavy rolling loads.

ROUTINE MAINTENANCE:ElectraThane ClearCoat is an extremely durable product. After application and curing of ElectraThane routine maintenance (to be expected with any floor) is all that is required to maintain the luster and conductivity of the finish. It's important to remove abrasives that can scratch and degrade the conductivity by dust mopping (usually on a daily basis). On an occasional basis (most of our clients prefer to do this once a week) wet mop the floor with a diluted mixture of ElectraClean and water and allow to dry. ElectraClean works great with power scrubbing equipment OR in hand mop applications. ElectraClean removes dirt and abrasives that dry mopping leaves behind and smells great too. Note: Do not wash your ElectraThane ESD Floor sealer for at least 48 hours after application and NEVER wash ElectraThane with plain water (always use ElectraClean diluted with water) for damp moping.