SDS SHEET

APPLICATION: ElectraThane is recommended for applications on all standard hard surface flooring and fully cured ElectraGuard ESD Epoxy (minimum curing time of ElectraGuard is 3 days at > 60 Deg F with adequate air movement). Thoroughly remove loose dirt and dust via sweeping (do not use sweeping compounds). Agitate ElectraThane ClearCoat in container prior to use, pour into clean contaminant free bucket and mop on one thin even coat using non linting synthetic finish mops. Allow coat to dry (depending on humidity and temperature) for 60 to 90 minutes before re-application of second coat. Three to Four coats are recommended for hard surface flooring. 2 coats maximum are recommended for ElectraGuard. Effective recoating may be achieved in the following manner: Vacuum the floor to remove any loose dirt or dust. Wash the floor with ElectraClean to remove dirt and soil, allow to dry thoroughly. Apply thin even coats using a lint free finish mop. Allow ElectraThane to dry for approximately 90 minutes between coats and before resumption of foot traffic. Allow to dry 24 hours prior to resumption of heavy rolling loads.