ElectraGlaze
ESD Floor Finish
Application: ESD floor finish is not applied like standard floor finish,
take the time to
understand the difference. If the flooring has been previously coated
with products other than those supplied by United SCP, is
dirty or dingy or has been coated by the flooring
manufacturer, strip the floor using
ElectraStrip. Follow
the directions for dilution and use and double rinse with
cool clean water prior to applying ElectraGlaze.
Always use clean containers and non linting finish mops
or
wax applicators to apply
ElectraGlaze. For string style mops soak the mop to remove any impurities and rinse
thoroughly. Wring out the mop as dry as possible and dip the mop into the
E-Glaze. Wring out the mop so that it does not drip and apply a thin
even
coat of E-Glaze to the entire floor. Don't allow the mop to become dried out
as streaks in the floor will result. Allow the floor to dry thoroughly. The
drying time will vary depending on temperature and humidity generally taking
between 2 to 4 hours. After the first thin coat has dried for at least 2
hours reapply a second coat. For ESD flooring 2 coats are ideal. High speed
polish for ultimate shine using
ElectraShine Spray Buff.
Maintenance: Dry dust mop frequently to remove abrasives
and dirt that can degrade the performance of the anti-static
properties. Remove scuff marks by spray buffing with a clean
pad and
ElectraShine Spray Buff.
Damp mop the floor only as needed
using ElectraClean.
Note: ESD
floor finishes (from United or any other Manufacturer) will
not reliably render standard flooring conductive enough to
meet the latest ANSI standards. To reliably provide this
level of conductivity
coat the standard flooring as is shown here.